LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2022 >> Transit Connect Titanium, Gas/Ethanol >> Repair and Diagnosis >> External Pages >> Different car >> Section 742 (Abs Guided Routine - Pinpoint Tests G - ZA) >> Pinpoint Tests Ya: Software Incompatibility With Brake Booster Control >> Normal Operation And Fault Conditions

Normal Operation And Fault Conditions

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2021 Lincoln Corsair, 2021 Ford Transit-350 HD, 2021 Ford Transit-350, 2021 Ford Transit-250, and 2021 Ford Transit-150. However, it is still accessible from the selected car via links, so may be relevant.

Some engines are also equipped with a VSV. The VSV replaces the traditional vacuum check valve usually located in the brake booster. The VSV is located in the vacuum harness and is used for stop-start applications, to shut off air conditioning in warm or hot markets and to supply additional vacuum to the brake booster for brake performance during specific driving conditions.

The VSV is controlled by the PCM. When the demand for vacuum increases, the PCM grounds the VSV and vacuum is routed to the brake booster. The PCM must be configured correctly for VSV operation, if a VSV is installed on a vehicle and the PCM is not configured for a VSV, this DTC sets.

PPT YA PCM DTC FAULT TRIGGER CONDITIONS

DTC Description Fault Trigger Conditions
U034B Software Incompatibility with Brake Booster Control This DTC sets due to incomplete or improper PMI procedures.
scientia non olet · About LEMON Manuals