Normal Operation And Fault Conditions

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2021 Lincoln Corsair, 2021 Ford Transit-350 HD, 2021 Ford Transit-350, 2021 Ford Transit-250, and 2021 Ford Transit-150. However, it is still accessible from the selected car via links, so may be relevant.

On certain 4x4 vehicles, the ATCM is used to activate and deactivate the selectable drive mode feature. When the driver presses or rotates the ATCM drive mode switch, the ATCM sends a drive mode message out on the HS-CAN2. When the ABS module receives this message, it takes the necessary action depending on the selectable drive mode message.

On 4x2 vehicles and certain 4x4 vehicles, the selectable drive mode switch in the IP console switch assembly is used to activate and deactivate the selectable drive mode feature. When the driver presses the selectable drive mode switch, the FCIM receives a ground signal over a dedicated circuit. The FCIM sends a drive mode message to the GWM over the HS-CAN 3, the GWM relays this message to the ABS module over the HS-CAN 2. The ABS module takes the necessary action depending on the selectable drive mode message.

PPT OB ABS MODULE DTC FAULT SETTING CONDITIONS

DTC	Description	Fault Setting Conditions
P05D3:86	Driver Mode Select Switch 'A' Range/Performance: Signal Invalid	This DTC sets when the selectable drive mode message sent from the ATCM indicates a stuck switch, when the switch has been pressed for longer than 30 seconds, or a general failure of the switch.