LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2022 >> Transit Connect Titanium, Gas/Ethanol >> Repair and Diagnosis >> External Pages >> Different car >> Section 737 (Supplemental Restraint System - Pinpoint Tests BA Through BT) >> Pinpoint Test BQ: U3000:41, U3000:42, U3000:46

Pinpoint Test BQ: U3000:41, U3000:42, U3000:46

WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
  1. Normal Operation and Fault Conditions 

    The OCS sensor is internal to the OCSM and cannot be serviced separately. For more information refer to REFER to: Airbag and Seatbelt Pretensioner Supplemental Restraint System (SRS) - System Operation and Component Description .

    DTC Fault Trigger Conditions 

    DTC Description Fault Trigger Condition
    OCSM U3000:41 Control Module: General Checksum Failure This DTC sets due to an internal fault with the OCSM.
    OCSM U3000:42 Control Module: General Memory Failure This DTC sets due to an internal fault with the OCSM.
    OCSM U3000:46 Control Module: Calibration/Parameter Memory Failure This DTC sets due to an internal fault with the OCSM.

    Possible Sources 

    • OCSM

  2. WARNING: Incorrect repair techniques or actions can cause an accidental Supplemental Restraint System (SRS) deployment. Never compromise or depart from these instructions. Failure to precisely follow all instructions could result in serious personal injury from an accidental deployment.
  3. NOTE: Use the correct probe adapter(s) when making measurements. Failure to use the correct probe adapter(s) may cause damage to the connector.
  4. NOTE: Most faults are due to connector and/or wiring concerns. Carry out a thorough inspection and verification before proceeding with the pinpoint test.
  5. NOTE: Only disconnect or reconnect SRS components when instructed to do so within a pinpoint test step. Failure to follow this instruction may result in incorrect diagnosis of the SRS.
  6. NOTE: Always make sure the correct SRS component is being installed. Parts released for other vehicles may not be compatible even if they appear physically similar. Check the part number listed in the Ford parts catalog to make sure the correct component is being installed. If an incorrect SRS component is installed, Diagnostic Trouble Codes (DTCs) may set.
  7. NOTE: The SRS must be fully operational and free of faults before releasing the vehicle to the customer.

  8. BQ1 CHECK FOR DIAGNOSTIC TROUBLE CODES (DTCS)

    • WARNING: Before beginning any service procedure In this article, refer to Safety warnings in General Information. Failure to follow this instruction may result in serious personal injury.

      Using a diagnostic scan tool, clear all Diagnostic Trouble Codes (DTCs).

    • NOTE: When selecting Restraints from the Self Test menu, DTCs are retrieved from the RCM and OCSM.

      Using a diagnostic scan tool, perform

      Restraints  self-test.

    Did the DTC return? 

    Yes  INSTALL a new OCSM. REFER to: Occupant Classification System (OCS) Sensor - Vehicles With: Multi-Contour Seats . or REFER to: Occupant Classification System (OCS) Sensor - Vehicles Without: Multi-Contour Seats .
    No  The system is operating correctly at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.
scientia non olet · About LEMON Manuals