LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2022 >> Transit Connect Titanium, Gas/Ethanol >> Repair and Diagnosis >> External Pages >> Different car >> Section 737 (Supplemental Restraint System - Pinpoint Tests BA Through BT) >> Pinpoint Test BG: OCS (Occupant Classification System) Concerns

Pinpoint Test BG: OCS (Occupant Classification System) Concerns

WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
  1. Normal Operation and Fault Conditions 

    The OCS sensor is internal to the OCSM and cannot be serviced separately. For more information refer to REFER to: Airbag and Seatbelt Pretensioner Supplemental Restraint System (SRS) - System Operation and Component Description .

    DTC Fault Trigger Conditions 

    DTC Description Fault Trigger Condition
    OCSM B00C0:11 Passenger Seat Occupant Classification Sensor "A": Circuit Short To Ground This DTC sets due to an internal fault with the OCSM.
    OCSM B00C0:12 Passenger Seat Occupant Classification Sensor "A": Circuit Short To Battery This DTC sets due to an internal fault with the OCSM.
    OCSM B00C0:16 Passenger Seat Occupant Classification Sensor "A": Circuit Voltage Below Threshold This DTC sets due to an internal fault with the OCSM.
    OCSM B00C0:49 Passenger Seat Occupant Classification Sensor "A": Internal Electronic Failure This DTC sets due to an internal fault with the OCSM.
    OCSM B00C0:7B Passenger Seat Occupant Classification Sensor "A": Low Fluid Level This DTC sets if the OCSM senses that OCS sensor readings are too low.

    Possible Sources 

    • Incorrect OCS sensor installation
    • OCS sensor damaged
    • Passenger seat damaged.
    • OCSM

    Visual Inspection and Pre-checks 

    • Review recent service history to identify repairs where an incorrect component may have been installed.
    • Inspect passenger seat for recent repairs.

  2. BG1 CHECK THE OCS (OCCUPANT CLASSIFICATION SYSTEM) SENSOR INSTALLATION

    • Ignition OFF.

    • Inspect the passenger seat for damage or incorrect installation. REFER to: Front Seat .

    • Inspect the OCS sensor installation and make sure that the hardware is fully seated and tightened correctly.

    • Inspect the OCS sensor hose for kinks, damage, or improper routing.

    Were any concerns found? 

    Yes  REPAIR as necessary.
    No  INSTALL a new OCS sensor. REFER to: Occupant Classification System (OCS) Sensor - Vehicles With: Multi-Contour Seats . or REFER to: Occupant Classification System (OCS) Sensor - Vehicles Without: Multi-Contour Seats .