Pinpoint Test BB: U2024:51, U2100:00
WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
- Normal Operation and Fault Conditions
DTC Fault Trigger Conditions
DTC Description Fault Trigger Condition RCM U2024:51 Control Module Cal-Config Data: Not Programmed This DTC sets due to incomplete or improper PMI. RCM U2100:00 Initial Configuration Not Complete: No Sub Type Information This DTC sets due to incomplete or improper PMI. Possible Sources
- Incomplete or improper PMI
- WARNING: Do not handle, move or change the original horizontal mounting position of the Restraints Control Module (RCM) while the Restraints Control Module (RCM) is connected and the ignition switch is ON. Failure to follow this instruction may result in the accidental deployment of the Safety Canopy® and cause serious personal injury or death.
- NOTE: Always make sure the correct SRS component is being installed. Parts released for other vehicles may not be compatible even if they appear physically similar. Check the part number listed in the Ford parts catalog to make sure the correct component is being installed. If an incorrect SRS component is installed, Diagnostic Trouble Codes (DTCs) may set.
- NOTE: The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
- BB1 CARRY OUT PMI (PROGRAMMABLE MODULE INSTALLATION)
- CHECK vehicle history for recent service actions related to the RCM.
Were there any recent service actions with the RCM?
Yes REPEAT the PMI procedure as directed by the diagnostic scan tool using As-Built data. No CHECK OASIS for any applicable service articles: TSB, GSB, SSM or FSA. If a service article exists for this concern, DISCONTINUE this test and FOLLOW the service article instructions. If no service articles address this concern, INSTALL a new RCM. Use As-Built data when carrying out PMI. REFER to: Restraints Control Module (RCM) .