Inspection and Repair After a Supplemental Restraint System (SRS) Deployment

WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

Inspection

NOTE: Deployable devices such as airbags, pretensioners and inflatable belt inflators, may deploy alone or in various combinations depending on the impact event.

NOTE: Always refer to the appropriate service information procedures prior to carrying out vehicle repairs affecting the SRS and seatbelt system.

NOTE: The SRS must be fully operational and free of faults before releasing the vehicle to the customer.

NOTE: Refer to the correct removal and installation procedure for all SRS components being installed.

When any deployable device or combination of devices have deployed and/or the RCM has DTC B1193:00 (event threshold exceeded) in memory, the repair of the vehicle SRS is to include the removal of all deployed devices and the installation of new deployable devices, the removal of all impact sensors and installation of new impact sensors and the removal and installation of a new RCM. Diagnostic Trouble Codes (DTCs) must be cleared from all required modules after repairs are carried out.
NOTE: After installation of new OCS components, use a diagnostic scan tool to carry out the OCS Reset procedure as instructed in the service information.

When a vehicle has been involved in a collision and the OCSM has DTC B1193:00 stored in memory, inspect the OCS for damage and repair as necessary. If installation of an OCS component is required, an OCS service kit must be installed.
When any damage to the impact sensor mounting points or mounting hardware has occurred, repair or install new mounting points and mounting hardware as needed.
When the driver airbag has deployed, install a new steering wheel and clockspring.
NOTE: Precise tolerances are required when manufacturing a steering column. Never install a repaired, rebuilt or remanufactured steering column, always install a new steering column. Failure to follow this direction can result in steering column failure.

Install a new adaptive energy absorption steering column if:
- Steering wheel is bent, loose or damaged
- Steering column functionality is binding, bent or sticking
- Steering column bearings brinelling or damaged
- Steering shaft bent, loose or damaged
- Any abnormal steering column movement
New driver and/or front passenger seatbelt systems (including seatbelt retractors, seatbelt buckles and height adjusters) must be installed if the vehicle is involved in a collision that results in deployment of the driver and/or front passenger seatbelt pretensioners.
New second row seatbelt systems (including seatbelt retractors, seatbelt buckles and inflators) must be installed if the vehicle is involved in a collision that results in deployment of the rear seatbelt pretensioners (if equipped) or inflatable seatbelt system (if equipped).
Inspect the entire vehicle for damage, including the following components:
- Instrument panel and mounting points
- Instrument panel braces and brackets
- Instrument panel knee bolsters and mounting points
- Side curtain airbag and mounting points
- Seatbelts, seatbelt buckles, seatbelt retractors and seatbelt anchors.
- Seats and seat mounting points
- SRS wiring, wiring harnesses and connectors
After carrying out the review and inspection of the entire vehicle for damage, repair or install new components as needed.
Inspect the fuel system for damage or leaks. Repair the system and install new components as necessary.
This vehicle is equipped with a fuel pump shut-off feature. During a crash event, it's possible that the fuel pump could be shut off. For additional information, refer to Fuel Pump Shut-off Feature in the Description and Operation portion of the appropriate Fuel Systems article.