Rear Door Window Glass - SuperCab, Vehicles With: Rear Power Windows: Removal

WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Left hand (LH) shown in illustration, right hand (RH) similar.

NOTE: Removal steps in this procedure may contain installation details.

Remove the rear door window control switch. Refer to: Rear Door Window Control Switch - SuperCab, Vehicles With: Rear Power Windows .
Remove the rear door trim panel. Refer to: Rear Door Trim Panel - SuperCab .
Remove the rear door watershield.

Courtesy of FORD MOTOR COMPANY
NOTE: The rear door shown in illustration transparent for clarity.

Remove the bolts and aft rear door glass run and bracket.

Torque

: 93 lb.in (10.5 Nm)

Courtesy of FORD MOTOR COMPANY
NOTE: For non-functional rear door window regulators and motors with the window in the 40 mm open to full closed position, cut the rear door window regulator cables to allow window movement.

Lower the rear door window glass to the full down position.
1. Connect the rear door window control switch.
2. Lower the rear door window glass to the full down position.
3. Remove the rear door window control switch.
Courtesy of FORD MOTOR COMPANY
Remove the rear door inner belt moulding.

Courtesy of FORD MOTOR COMPANY
Remove the rear door upper moulding. Refer to: Rear Door Upper Moulding .
Remove the rear door glass top run.

Courtesy of FORD MOTOR COMPANY
Raise the rear door window glass to one third up position.
1. Connect the rear door window control switch.
2. Raise the rear door window glass to one third up position.
3. Remove the rear door window control switch.
Courtesy of FORD MOTOR COMPANY
Remove the rear door window glass.
1. Release the rear door window glass retaining clip.
  Use the General Equipment: Interior Trim Remover
2. Remove the rear door window glass.

Courtesy of FORD MOTOR COMPANY