Pinpoint Test D: B115E:97, B15E1:97 Or B15E2:97
WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
- Refer to CRUISE CONTROL
for schematic and connector information.
Normal Operation and Fault Conditions
REFER to: Interior Camera System - System Operation and Component Description .
DTC Fault Trigger Conditions
DTC Description Fault Trigger Condition CMR B115E:97 Camera Module: Component Or System Operation Obstructed Or Blocked A continuous memory and on-demand DTC that sets when the driver status monitor camera module detects that the camera is obstructed or blocked. CMR B15E1:97 Driver Side LED: Component Or System Operation Obstructed Or Blocked A continuous memory and on-demand DTC that sets when the driver status monitor camera module detects that the driver side LED is obstructed or blocked. CMR B15E2:97 Passenger Side LED: Component Or System Operation Obstructed Or Blocked A continuous memory and on-demand DTC that sets when the driver status monitor camera module detects that the passenger side LED is obstructed or blocked. Possible Sources
- Blockage or obstruction
- Driver status monitor LED
- Driver status monitor camera
Visual Inspection and Pre-checks
- Inspect the driver status monitor camera or driver status monitor LED for damage.
- D1 CHECK THE DRIVER STATUS MONITOR CAMERA MODULE DIAGNOSTIC TROUBLE CODES
- Ignition ON.
- Connect the diagnostic tool.
- Using the diagnostic scan tool, clear the DTC.
- Ignition OFF.
- Ignition ON.
- Close the driver door and wait 15 seconds.
- Using the diagnostic scan tool, perform the CMR self-test.
Is DTC B115E:97, B15E1:97 or B15E2:97 still present?
Yes GO to D2 No The system is operating correctly at this time. The DTC may have been set due to an previous obstruction or blockage that has been removed. - D2 INSPECT THE CAMERA AND LEDS FOR OBSTRUCTIONS
- Inspect the driver status monitor camera and LEDs for obstructions from;
- Dirt or debris
- Aftermarket equipment
- Electronic devices and accessory power cords
- Auxiliary power cords
Is the driver status monitor camera or LED obstructed or blocked?
Yes Clean or remove the obstruction. No GO to D3 - Inspect the driver status monitor camera and LEDs for obstructions from;
- D3 INSTALL CMR (CAMERA MODULE - REAR) PMI (PROGRAMMABLE MODULE INSTALLATION)
- Using a diagnostic scan tool, clear the Diagnostic Trouble Codes (DTCs).
- Install CMR As-Built data from PTS following scan tool instructions.
Is DTC B115E:97, B15E1:97 or B15E2:97 still present?
Yes REPLACE the suspect component. For the driver status monitor camera, REFER to: Driver Status Monitor Camera . For the driver side driver status monitor LED, REFER to: Driver Side Driver Status Monitor LED . For the passenger side driver status monitor LED, REFER to: Passenger Side Driver Status Monitor LED . No The system is operating correctly at this time.