Pinpoint Test F: U3000:41, U3000:42, U3000:49
WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
- Refer to CHARGING SYSTEM
for schematic and connector information.
Normal Operation and Fault Conditions
REFER to: Wireless Accessory Charging Module (WACM) - System Operation and Component Description .
DTC Fault Trigger Conditions
DTC Description Fault Trigger Condition WACM U3000:41 Control Module: General Checksum Failure This DTC sets due to incomplete or improper PMI procedures. WACM U3000:42 Control Module: General Memory Failure This DTC sets due to incomplete or improper PMI procedures. WACM U3000:49 Control Module: Internal Electronic Failure This DTC sets in the WACM Field-Effect Transistor (FET) protective circuit strategy for its actuator outputs has reached 100%. Possible Sources
- Vehicle communication bus
- Incomplete or improper PMI procedures
- WACM
- F1 RECHECK THE WACM (WIRELESS ACCESSORY CHARGING MODULE) DTCS (DIAGNOSTIC TROUBLE CODES)NOTE: If new modules were installed prior to the DTC being set, the module configuration may be incorrectly set during the PMI or the PMI may not have been carried out.NOTE: Every effort should be made to not trigger a key search by opening a door, stepping on the brake pedal. The triggering of a key search temporarily disables the WACM by design to avoid interference between the BCM and Key fob. This can cause confusion and the unnecessary replacement of perfectly good modules. While no key searches are being conducted while running the test results in no DTCs. This needs to be understood for the true DTCs setting and symptoms to be diagnosed.
- Using a diagnostic scan tool, clear the Diagnostic trouble Codes (DTCs).
- Ignition OFF.
- Ignition ON.
- Wait 10 seconds.
- Using a diagnostic scan tool, perform the WACM self-test.
Is 2100:00, U3000:41 or U3000:49 present?
Yes For DTC U3000:41, U3000:42, PERFORM the PMI procedure on the WACM. REFER to: Module Programming . For DTC U3000:49, INSTALL a new WACM REFER to: Wireless Accessory Charging Module (WACM) . No The system is operating correctly at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.