Pinpoint Test K: U3000:41, U3000:42, U3000:96
WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
- Normal Operation and Fault Conditions
The PACM monitors internal memory status and memory programming and sets Diagnostic Trouble Codes when a concern is present.
DTC Fault Trigger Conditions
DTC Description Fault Trigger Condition PACM U3000:41 Control Module: General Checksum Failure This DTC sets when an internal programming checksum concern exists in the PACM. PACM U3000:42 Control Module: General Memory Failure This DTC sets when an internal memory concern exists in the PACM. PACM U3000:96 Control Module: Component Internal Failure This DTC sets when an internal concern exists in the PACM. Possible Sources
- Internal PACM concern
- K1 RECHECK THE PACM (PEDESTRIAN ALERT CONTROL MODULE) DIAGNOSTIC TROUBLE CODES (DTCS)
- Ignition ON.
- Using a diagnostic scan tool, clear the Diagnostic Trouble Codes (DTCs).
- Wait 10 seconds.
- Using a diagnostic scan tool, perform the PACM self-test.
Is DTC U3000:41, U3000:42 or U3000:96 still present?
Yes INSTALL a new PACM. REFER to: Pedestrian Alert Control Module (PACM) . No The PACM is operating correctly at this time. The concern may have been caused by a temporary low battery condition.