Digital Rear Parking Aid Camera
WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Use caution when handling the coaxial cables. Damage may occur if the cable is bent at too sharp of an angle.
The rear parking aid camera is located on the tailgate. On vehicles equipped with a digital rear parking aid camera, the rear camera communicates with the IPMA through a coaxial cable in a digital serial format (LVDS). On vehicles equipped with an analog rear parking aid camera, the rear parking aid camera communicates with the BCM through a LIN circuit. When replacing the analog rear parking aid camera, it must be configured using a diagnostic scan tool after replacement in order for all features to operate properly.
On vehicles equipped with the 360 degree view camera system, the 360 degree view camera alignment must be performed after the tailgate, or the rear parking aid camera is removed from the vehicle.