Seatbelt Shoulder Height Adjuster - SuperCab: Removal

WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Removal steps in this procedure may contain installation details.

NOTE: LH (left-hand) shown in illustration, RH (right-hand) similar.

Release the tab and remove the front seatbelt retractor and pretensioner D-ring bolt cover.

Courtesy of FORD MOTOR COMPANY
Remove the bolt and position the front seatbelt retractor and pretensioner D-ring aside.
Torque

: 30 lb.ft (40 Nm)

Courtesy of FORD MOTOR COMPANY
Release the retainers and remove the rear door upper trim panel.

Courtesy of FORD MOTOR COMPANY
Remove and discard the seatbelt shoulder height adjuster weather seal.

Courtesy of FORD MOTOR COMPANY
NOTE: Do not use excessive force pulling the seatbelt shoulder height adjuster release latch when the front seatbelt retractor and pretensioner D-ring cover has been removed. Failure to follow this instruction may cause the release latch to be dislodged from the seatbelt shoulder height adjuster assembly.

Pull the release latch and slide the seatbelt shoulder height adjuster down.

Courtesy of FORD MOTOR COMPANY
Position the seatbelt shoulder height adjuster.
1. Remove the bolt.
  Torque
  
  : 30 lb.ft (40 Nm)
2. Rotate the seatbelt shoulder height adjuster 90 degrees clockwise.
Courtesy of FORD MOTOR COMPANY
Detach the lower tab and remove the seatbelt shoulder height adjuster.

Courtesy of FORD MOTOR COMPANY