Pinpoint Test E: P0607
WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
- Normal Operation and Fault Conditions
REFER to: Electric Powertrain Control - Component Location .
DTC Fault Trigger Conditions
DTC Description Fault Trigger Condition SOBDMC P0607:00 Control Module Performance: No Sub Type Information This DTC sets when an internal hardware fault is detected. Possible Sources
- Inverter System Controller (ISC) calibration
- Inverter System Controller (ISC)
- E1 CLEAR AND CHECK THE INVERTER SYSTEM CONTROLLER (ISC) DIAGNOSTIC TROUBLE CODES (DTCS)
- Using a diagnostic scan tool, clear the Inverter System Controller (ISC) DTCs.
- Using a diagnostic scan tool, perform the Inverter System Controller (ISC) self-test.
Is DTC P0607 present?
Yes CHECK OASIS for any applicable service articles: TSB, GSB, SSM or FSA. If a service article exists for this concern, DISCONTINUE this test and FOLLOW the service article instructions. If no service articles address this concern, INSTALL a new Inverter System Controller (ISC). REFER to: Inverter System Controller [SOBDMC] . No The system is operating correctly at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.