Pinpoint Test BP: U2100
WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
- Normal Operation and Fault Conditions
REFER to: Electric Powertrain Control - Component Location .
DTC Fault Trigger Conditions
DTC Description Fault Trigger Condition SOBDMC U2100:00 Initial Configuration Not Complete: No Sub Type Information This DTC sets when the transmission identification (TRID) data is missing from the SOBDMC. Possible Sources
- Inverter System Controller (ISC) configuration
- BP1 PERFORM THE TRANSMISSION STRATEGY DOWNLOAD
- Ignition ON.
- Using a diagnostic scan tool, perform the Transmission Strategy Download. REFER to: Transmission Strategy Download .
- Using a diagnostic scan tool, clear the Inverter System Controller (ISC) DTCs.
- Ignition OFF.
- Wait 60 seconds.
- Ignition ON.
- Using a diagnostic scan tool, perform the Inverter System Controller (ISC) self-test.
Is DTC U2100 present?
Yes CHECK OASIS for any applicable service articles: TSB, GSB, SSM or FSA. If a service article exists for this concern, DISCONTINUE this test and FOLLOW the service article instructions. If no service articles address this concern, It is necessary to seek additional help. REFER to the Service Repair And Technical Assistance Process. A vehicle data recorder (VDR) or similar recorder may also be useful. No The system is operating correctly at this time. The DTC may have been set due to missing or corrupted transmission identification (TRID) data.