Pinpoint Test As: P0C6C

WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

Normal Operation and Fault Conditions

REFER to: Electric Powertrain Control - Component Location .

DTC Fault Trigger Conditions

DTC	Description	Fault Trigger Condition
SOBDMC P0C6C:00	Generator Position Sensor Circuit "B" High: No Sub Type Information	This DTC sets when a short to power is detected in the generator resolver circuit.

Possible Sources

Wiring, terminals or connectors
Inverter System Controller (ISC) calibration

AS1 CHECK THE INVERTER SYSTEM CONTROLLER (ISC) CALIBRATION LEVEL

NOTE: Wiring overlays or repinning of circuits are NOT appropriate for DTC P0C6C due to risk of hardware damage.
- Verify the Inverter System Controller (ISC) is at the latest calibration level.
Is the Inverter System Controller (ISC) at the latest calibration level?

Yes GO to AS2

No UPDATE the Inverter System Controller (ISC) to the latest calibration level.

AS2 CHECK FOR DTC (DIAGNOSTIC TROUBLE CODE) P0C6C

Ignition ON.

Using a diagnostic scan tool, retrieve all Inverter System Controller (ISC) DTCs.

Was DTC P0C6C read from the Inverter System Controller (ISC)?

Yes

GO to AS3

No	The system is operating correctly at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.

AS3 VISUAL INSPECTION OF THE LOW VOLTAGE SYSTEM
- Ignition OFF.
- Remove the high voltage traction battery service disconnect plug.
- Visually inspect all the low voltage cables.
- Make sure all the low voltage connectors are correctly and securely connected.
- Examine all the low voltage cables and connectors for damaged, burned or overheated insulation and loose or broken connections.
Is a concern present?

Yes REPAIR as necessary. CLEAR the DTCs and REPEAT the self-test.

No GO to AS4

AS4 CHECK THE GS4 CIRCUIT FOR A SHORT TO VOLTAGE

Disconnect Inverter System Controller (ISC) C1458A.

Disconnect Transmission Sensor Speed Resolver C1280.

Ignition ON.

Measure and record:

Positive Lead	Measurement / Action	Negative Lead
C1458A-A2	Courtesy of FORD MOTOR COMPANY	Ground

Is any voltage present?

Yes	REPLACE the harness. CLEAR the DTCs and REPEAT the self-test.

GO to AS5

AS5 CHECK FOR CORRECT INVERTER SYSTEM CONTROLLER (ISC) OPERATION

Ignition OFF.

Inspect all Inverter System Controller (ISC) connectors.

Repair:
- corrosion (install new connector or terminals - clean module pins)
- damaged or bent pins - install new terminals/pins
- pushed-out pins - install new pins as necessary

Reconnect all of the previously disconnected connectors. Make sure they seat and latch correctly.

Ignition ON.

Using a diagnostic scan tool, clear all Inverter System Controller (ISC) DTCs.

Using a diagnostic scan tool, retrieve all Inverter System Controller (ISC) DTCs.

Is DTC P0C6C present?

Yes

CHECK OASIS for any applicable service articles: TSB, GSB, SSM or FSA. If a service article exists for this concern, DISCONTINUE this test and FOLLOW the service article instructions. If no service articles address this concern, REFER to: Powertrain Control Module (PCM) Input and Output Controls . Pinpoint Test Z.

No	The system is operating correctly at this time. The concern may have been caused by module connections. ADDRESS the root cause of any connector or pin issues.