Exhaust Gas Recirculation (EGR) Coolant Inlet Tube: Removal
WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Removal steps in this procedure may contain installation details.
- Remove the fender splash shield. Refer to: Fender Splash Shield .
- Drain the cooling system. Refer to: Engine Cooling System Draining, Vacuum Filling and Bleeding .
- Remove the fastener and position aside the EGR coolant inlet tube.
- Inspect the O-ring seal and replace if necessary.
- Remove fastener and EGR coolant inlet tube.
- Inspect the O-ring seal and replace if necessary.