Fuel Rail LH: Removal
WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Do not work on the fuel system until the pressure has been released and the engine has cooled. Fuel in the high-pressure fuel system is hot and under very high pressure. High-pressure fuel may cause cuts and contact with hot fuel may cause burns. Failure to follow these instructions may result in serious personal injury.
NOTE:
Fuel injection equipment is manufactured to very precise tolerances and fine clearances. To prevent fuel system damage, it is essential that absolute cleanliness is observed when working with these components.
- Remove the exhaust gas recirculation (EGR) system module. Refer to: Exhaust Gas Recirculation (EGR) System Module .
- Remove and discard the fuel rail supply tube LH. Refer to: Fuel Rail Supply Tube LH .
- Remove and discard the fuel injector supply tubes LH. Refer to: Fuel Injector Supply Tube LH .
- Remove and discard the fuel rail balance tube. Refer to: Fuel Rail Balance Tube .
- Disconnect the electrical connector, then remove the bolt and move the wire bracket out of the way.
- Remove the bolts, then remove the left fuel rail.