Throttle Body: Installation

WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Make sure that the mating faces are clean and free of foreign material.
Inspect the throttle body gasket, clean and replace the throttle body gasket as needed.

Courtesy of FORD MOTOR COMPANY
Install the throttle body, then install and tighten the throttle body bolts in the following 2 stages.
Torque

:Stage 1: 89 lb.in (10 Nm)

Stage 2: 90°

Courtesy of FORD MOTOR COMPANY
NOTE: When connecting the throttle body electrical connector engage the red connector locking tab after fully installing the throttle body electrical connector. The red tab will not slide forward unless the throttle body electrical connector is fully installed.

Connect the throttle body electrical connector.

Courtesy of FORD MOTOR COMPANY
Install the charge air cooler outlet pipe, then tighten the charge air cooler outlet pipe clamp.
Torque

: 44 lb.in (5.0 Nm)

Courtesy of FORD MOTOR COMPANY
Install the charge air cleaner outlet pipe RH. Refer to: Air Cleaner Outlet Pipe RH .
NOTE: PowerBoost shown in illustration, EcoBoost is similar.

Install the engine appearance cover into the rear retain tabs on the intake manifold, then install and tighten the engine appearance cover retainers.

Torque

: 97 lb.in (11 Nm)

Courtesy of FORD MOTOR COMPANY
Road test the vehicle.