Turbocharger Oil Supply Tube LH: Removal
WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The turbocharger compressor vanes can be damaged by even the smallest particles. When removing any turbocharger or engine air intake system component, ensure that no debris enters the system. Failure to do so may result in damage to the turbocharger.
NOTE:
Special attention needs to be given to the sealing ports for the oil feed, the oil drain, and the coolant lines, on turbocharged engines. The sealing ports must be totally clean and free from O-ring residue, have no damage to the sealing surface and the lines to ensure that there are no leaks or repeat repairs.
- Remove the engine rear undershield. Refer to: Engine Rear Undershield .
- Remove the left front fender splash shield. Refer to: Fender Splash Shield .
- Remove the charge air cooler intake pipe - left side. Refer to: Charge Air Cooler (CAC) Intake Pipe .
- Detach the harness retainer, then move the harness out of the way.
-
NOTE: The left turbocharger oil supply tube does not have a turbocharger oil supply filter.
Remove the turbocharger oil supply tube bolts, then remove and discard the turbocharger oil supply tube.