LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2022 >> Transit Connect Titanium, Gas/Ethanol >> Repair and Diagnosis >> External Pages >> Different car >> Section 642 (Automatic Transmission - 10-Speed Automatic Transmission - 10R80 (DTC Charts 5.0L - Assembly)) >> Removal And Installation >> Torque Converter Seal >> Removal

Torque Converter Seal: Removal

WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the transmission assembly. Refer to: Transmission .
  2. Using the special tool, install the transmission on a bench. Use Special Service Tool: 307-003 (T57L-500-B) Holding Fixture, Transmission.
    GFD558769Courtesy of FORD MOTOR COMPANY
  3. Remove the special tool. Use Special Service Tool: 307-346 (T97T-7902-A) Retainer, Torque Converter.
    GFD558770Courtesy of FORD MOTOR COMPANY
  4. Using the special tool, remove the torque converter. Use Special Service Tool: 307-091 Handle, Torque Converter.
    GFD558771Courtesy of FORD MOTOR COMPANY
  5. A new or remanufactured torque converter must be installed if one or more of the following statements are true:

    • The sealing surface has a groove worn from the seal.

    • A torque converter malfunction has been determined based on complete diagnostic procedures.

    • The torque converter stud or studs, threaded pads, impeller hub or bushing are damaged.

    • The torque converter exhibits external discoloration (due to overheating).

    • There is evidence of water or antifreeze contamination.

    GFD558772Courtesy of FORD MOTOR COMPANY
    1. Remove the torque converter hub seal snap ring.
    2. NOTE: When removing the torque converter hub seal use care not to scratch the front support cover sealing surface.

      Remove and discard the torque converter hub seal (7A248).

GFD558773Courtesy of FORD MOTOR COMPANY
scientia non olet · About LEMON Manuals