Output Shaft Seal: Installation
WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
- Using the special tool, install the new output shaft seal. Use Special Service Tool: 307-660 Installer, Front Pump Seal.
Rear Wheel Drive (RWD) vehicles
- Using the special tool, install the new output shaft nut. Use Special Service Tool: 307-776 Socket, Outputshaft Locknut.
Torque: 148 lb.ft (200 Nm)
- Apply a light coating of the lubrication to the back side of the anti-ting ring.
Material
: Motorcraft® High Temperature 4x4 Front Axle and Wheel Bearing Grease / XG-11 (WSS-M1C267-A1)
- Install the anti-ting ring.
- Apply a light coating of the lubrication to the output shaft splines and the anti-ting ring.
Material
: Motorcraft® High Temperature 4x4 Front Axle and Wheel Bearing Grease / XG-11 (WSS-M1C267-A1)
- Align the index marks on the output shaft and the output shaft flange made during removal.
- Install the new output shaft flange bolt.
Torque: 81 lb.ft (110 Nm)
- Install the rear driveshaft assembly. Refer to: Rear Driveshaft
.
Four-Wheel Drive (4WD) vehicles
- Install the transfer case assembly. Refer to: Transfer Case
.
All vehicles
- Check the transmission fluid level. Refer to: Transmission Fluid Level Check .