Pinpoint Test J: The Starter Does Not Disengage From The FLEXPLATE

WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

Normal Operation and Fault Conditions
REMOVE the starter relay. If the engine stops cranking, INSTALL a new relay. If the engine continues to crank, REPAIR circuit CDC35 (BU/WH) for a short to voltage.

Possible Sources
- Starter relay
- Wiring, terminals or connectors
Diagnostic steps are not provided for this symptom or DTC. REFER to: Diagnostic Methods