Turbocharger Oil Supply Tube LH: Installation
WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
-
NOTE: A new turbocharger oil supply tube filter must be installed. Failure to install a new filter will cause turbocharger failure.
Install the new O-ring seals and the new turbocharger oil supply tube oil filter. Lubricate the new O-ring seals with clean engine oil. Refer to: Specifications .
-
-
NOTE: Do not use a metal brush; damage to sealing area will result in leaks.
Carefully use a nylon brush to remove the old O-ring residue and use brake cleaner to rinse the O-ring residue out of the turbocharger tube to turbocharger O-ring bore and the turbocharger tube to engine O-ring bore. Inspect the area for deep scratches and gouges. Install new components as needed.
Material
: Motorcraft® Metal Brake Parts Cleaner / PM-4-A, PM-4-B
- Install the turbocharger oil supply tube, then loosely install the bolt.
-
- Connect the turbocharger oil supply tube to the turbocharger, then install and tighten the bolt.
Torque: 89 lb.in (10 Nm)
- Tighten the turbocharger oil supply tube bolt.
Torque: 89 lb.in (10 Nm)
- Install the new EGR tube gaskets.
- Install the EGR tube, then install and tighten the EGR tube retainers.
Torque: Tighten the nuts to : 89 lb.in (10 Nm) Tighten the bolts to : 89 lb.in (10 Nm)
- Install the air tube bracket, then install and the air tube bracket retainers.
Torque: Tighten the nut to : 53 lb.in (6 Nm) Tighten the bolt to : 53 lb.in (6 Nm)
- Install the left charge air cooler intake pipe. Refer to: Charge Air Cooler (CAC) Intake Pipe .
- Install the air cleaner outlet pipe LH. Refer to: Air Cleaner Outlet Pipe LH .
- Check and top off the engine oil level as needed. Refer to: Specifications .