Thermostatic Expansion Valve Manifold and Tube Assembly - 3.0L Power Stroke Diesel: Removal

WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: During the removal of components, cap, tape or otherwise appropriately protect all openings to prevent the ingress of dirt or other contamination. Remove protective materials prior to installation.

NOTE: Removal steps in this procedure may contain installation details.

Recover the refrigerant. Refer to the appropriate Recovery procedure in the appropriate Climate Control System article.
Remove the radiator grille. Refer to: Radiator Grille .
Remove the condenser outlet line nut and disconnect the fitting.
- Make sure to cover any open ports to prevent debris from entering the system.
  Torque: 71 lb.in (8 Nm)
Courtesy of FORD MOTOR COMPANY
Remove the battery tray. Refer to: Battery Tray .
Remove the thermostatic expansion valve manifold tube assembly bracket retainer.
Torque: 133 lb.in (15 Nm)

Courtesy of FORD MOTOR COMPANY
Remove the A/C compressor inlet line nut and disconnect the fitting.
- Make sure to cover any open ports to prevent debris from entering the system.
  Torque: 133 lb.in (15 Nm)
Courtesy of FORD MOTOR COMPANY
Remove the RHF fender splash shield. Refer to: Fender Splash Shield .
Remove the nut and the thermostatic expansion valve manifold and tube assembly.
- Make sure to cover any open ports to prevent debris from entering the system.
  Torque: 80 lb.in (9 Nm)

Courtesy of FORD MOTOR COMPANY