Pinpoint Test N: DTC (Diagnostic Trouble Code) B124E:96 Or B124E:9E: Notes
WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
Refer to WIPERS AND WASHERS for schematic and connector information.
Normal Operation and Fault Conditions
REFER to: Wipers and Washers - System Operation and Component Description .
DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Condition |
|---|---|---|
| SCCM B124E:96 | Wiper Stalk Switch Pack: Component Internal Failure | Sets when the SCCM detects an improper or unexpected signal from the wiper stalk switch pack. |
| SCCM B124E:9E | Wiper Stalk Switch Pack: Stuck On | Sets when the SCCM detects an improper or unexpected signal from the wiper stalk switch pack. |
Possible Sources
- Wiring, terminals or connectors
- Wiper/washer switch
- SCCM
NOTE:
Use the correct probe adapter(s) when making measurements. Failure to use the correct probe adapter(s) may damage the connector.