LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2022 >> Transit Connect Titanium, Gas/Ethanol >> Repair and Diagnosis >> External Pages >> Different car >> Section 622 (Wipers And Washers) >> Diagnosis And Testing >> Wipers and Washers >> Pinpoint Tests >> Pinpoint Test K: DTC B10AD:49 >> Wipers And Washers

Wipers And Washers

WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

  1. K1 CHECK FOR DTC B10AD:49

    • Ignition ON.

    • Verify the Rain Sensor is correctly installed.

    • Using a diagnostic scan tool, carry out the SCCM self test.

    • CLEAR all DTCs and carry out the SCCM self test again.

    Does DTC B10AD:49 return? 

    Yes  INSTALL a new rain sensor. REFER to: Rain Sensor . TEST the system for normal operation. If the concern is still present, CHECK OASIS for any applicable service articles: TSB, GSB, SSM, or FSA. If a service article exists for this concern, DISCONTINUE this test and FOLLOW the service article instructions. If no service articles address this concern, INSTALL a new SCCM. REFER to: Steering Column Control Module (SCCM) . REFER to: Steering Column Control Module (SCCM) - Vehicles With: Adaptive Steering .
    No  The system is operating correctly at this time. The concern may have been caused by an intermittent condition. DIAGNOSE the observable symptom.
scientia non olet · About LEMON Manuals