Diagnostic Trouble Code (DTC) Chart
WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
Diagnostics in this article assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods .
Diagnostic Trouble Code Chart
| Module | DTC | Description | Action |
|---|---|---|---|
| BCM | B130F:12 | Run Accessory Control: Circuit Short To Battery | GO to Pinpoint Test A |
| BCM | B130F:14 | Run Accessory Control: Circuit Short To Ground or Open | GO to Pinpoint Test A |
| BCM | B130F:14 | Run Accessory Control: Circuit Short To Ground or Open | GO to Pinpoint Test D |
| SCCM | B10AD:02 | Rain Sensor: General Signal Failure | GO to Pinpoint Test F |
| SCCM | B10AD:08 | Rain Sensor: Bus Signal / Message Failure | GO to Pinpoint Test F |
| SCCM | B10AD:49 | Rain Sensor: Internal Electronic Failure | GO to Pinpoint Test K |
| SCCM | B10AD:55 | Rain Sensor:Not Configured | GO to Pinpoint Test M |
| SCCM | B1131:02 | Wiper motor module: General Signal Failure | GO to Pinpoint Test A |
| SCCM | B1131:02 | Wiper Motor Module: General Signal Failure | GO to Pinpoint Test D |
| SCCM | B1131:08 | Wiper motor module: Bus Signal / Message Failure | GO to Pinpoint Test B |
| SCCM | B1131:11 | Wiper motor module: Circuit Short to Ground | GO to Pinpoint Test B |
| SCCM | B1131:49 | Wiper Motor Module: Internal Electronic Failure | GO to Pinpoint Test L |
| SCCM | B1131:55 | Wiper Motor Module: Not Configured | GO to Pinpoint Test M |
| SCCM | B1131:9A | Wiper motor module: Component or System Operating Conditions | GO to Pinpoint Test O |
| SCCM | B124E:96 | Wiper Stalk Switch Pack: Component Internal Failure | GO to Pinpoint Test N |
| SCCM | B124E:9E | Wiper Stalk Switch Pack: Stuck On | GO to Pinpoint Test N |