Pinpoint Test BJ: U2101:00
WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
- Normal Operation and Fault Conditions
The IPMA as well as all control modules that are programmable must have the correct As-Built data installed.
DTC Fault Trigger Conditions
DTC Description Fault Trigger Condition IPMA U2101:00 Control Module Configuration Incompatible: No Sub Type Information This continuous memory DTC sets when the IPMA As-Built data installation was not installed completely or incorrectly. Possible Sources
- IPMA
- BJ1 CONFIRM THE DTC RESETS
- Check vehicle service history for recent service actions related to the IPMA.
- Ignition ON.
- Connect the diagnostic tool.
- Using the diagnostic scan tool, clear the DTC.
- Wait 10 seconds.
- Using the diagnostic scan tool, perform the IPMA self-test.
Is DTC U2101:00 still present?
Yes GO to BJ2 No The system is operating correctly at this time. - BJ2 INSTALL IPMA (IMAGE PROCESSING MODULE A) PMI (PROGRAMMABLE MODULE INSTALLATION)
- Using a diagnostic scan tool, clear the DTCs.
- Install IPMA As-Built data from PTS following scan tool instructions.
Is DTC U2101:00 still present?
Yes CHECK OASIS for any applicable service articles: TSB, GSB, SSMor FSA. If a service article exists for this concern, DISCONTINUE this test and FOLLOW the service article instructions. If no service articles address this concern, INSTALL a new IPMA. REFER to: Image Processing Module A (IPMA) . No The system is operating correctly at this time.