Pinpoint Test AF: U2300:55
WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
- Normal Operation and Fault Conditions
REFER to: Lane Keeping System - System Operation and Component Description .
DTC Fault Trigger Conditions
DTC Description Fault Trigger Condition IPMA U2300:55 Central Configuration: Not Configured This continuous memory DTC can set in IPMA due to incomplete or incorrect PMI procedures. Possible Sources
- IPMA concern
- AF1 CHECK FOR THE CORRECT PMI (PROGRAMMABLE MODULE INSTALLATION) PROCEDURE
- Ignition ON.
- Using a diagnostic scan tool, clear the Diagnostic Trouble Codes (DTCs) for the module in question.
Is DTC U2300:55 still present?
Yes CHECK the vehicle service history for recent service actions related to this module. If there have been recent service actions with this module, INSTALL As-Built data from PTS, following the diagnostic scan tool instructions under Module Programming>As-Built. REFER to: Module Programming . If there have been no recent service actions, INSTALL a new module to correct the failure to retain configuration data. REFER to: Image Processing Module A (IPMA) . No The repair is complete.