LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2022 >> Transit Connect Titanium, Gas/Ethanol >> Repair and Diagnosis >> External Pages >> Different car >> Section 614 (Lane Keeping System) >> Diagnosis And Testing >> Lane Keeping System >> Pinpoint Tests >> Pinpoint Test AE: U2100:00

Pinpoint Test AE: U2100:00

WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
  1. Normal Operation and Fault Conditions 

    REFER to: Lane Keeping System - System Operation and Component Description .

    DTC Fault Trigger Conditions 

    DTC Description Fault Trigger Condition
    IPMA U2100:00 Initial Configuration Not Complete: No Sub Type Information This continuous memory DTC can set in IPMA due to incomplete or incorrect PMI procedures.

    Possible Sources 

    • PMI concern

  2. AE1 CHECK FOR THE CORRECT PMI (PROGRAMMABLE MODULE INSTALLATION) PROCEDURE

    • Ignition ON.

    • Using a diagnostic scan tool, clear the Diagnostic Trouble Codes (DTCs) for the module in question.

    Is DTC U2100:00 still present? 

    Yes  CHECK the vehicle service history for recent service actions related to this module. If there have been recent service actions with this module, INSTALL As-Built data from PTS, following the diagnostic scan tool instructions under Module Programming>As-Built. REFER to: Module Programming . If there have been no recent service actions, INSTALL a new module to correct the failure to retain configuration data. REFER to: Image Processing Module A (IPMA) .
    No  The repair is complete.
scientia non olet · About LEMON Manuals