Pinpoint Test J: The CENTERSTACK Infotainment Display Shows The Active Park Assist Not Available Message
WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
- Refer to MODULE COMMUNICATIONS NETWORK
for schematic and connector information.
Normal Operation and Fault Conditions
REFER to: Parking Aid - System Operation and Component Description .
Possible Sources
- AdvanceTrac® is off
- AdvanceTrac® event was in progress
- ABS event was in progress
- Battery was recently disconnected
- J1 VERIFY THE CONCERN
- Verify the concern.
Does the centerstack infotainment display show the active park assist is not available?
Yes The active park assist system is not available if the AdvanceTrac® is off or if an ABS or AdvanceTrac® event is in progress when the system is being activated by the driver. The active park assist system is not available immediately after a battery disconnect or if the PSCM and/or the ABS module were recently reprogrammed, or on a newly manufactured vehicle that has not been driven above 50 km/h (30 mph) with minimal driver steering input for 30 seconds. Abort this step at any time to maintain safe driving, and repeat the process if required. If completed correctly, active park assist will be available upon pressing the active park assist switch. No The system is working normally at this time.