Pinpoint Test R: DTC U3000:49
WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
- Normal Operation and Fault Conditions
REFER to: Steering Wheel and Column Electrical Components - System Operation and Component Description .
DTC Fault Trigger Conditions
DTC Description Fault Trigger Condition SCCM U3000:49 Control Module: Internal Electronic Failure This DTC sets when there is an Internal Electronic Failure in the SCCM. Possible Sources
- SCCM
- R1 CHECK FOR DTC U3000:49
- Ignition ON.
- Using a diagnostic scan tool, carry out the SCCM self test.
Is DTC U3000:49 present?
Yes CHECK OASIS for any applicable service articles: TSB, GSB, SSM, or FSA. If a service article exists for this concern, DISCONTINUE this test and FOLLOW the service article instructions. If no service articles address this concern, INSTALL a new SCCM. REFER to: Steering Column Control Module (SCCM) . REFER to: Steering Column Control Module (SCCM) - Vehicles With: Adaptive Steering . No The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector. ADDRESS the root cause of any connector or pin issues.