Pinpoint Test P: DTC U0422:08, U053B:08
WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
- Normal Operation and Fault Conditions
REFER to: Steering Wheel and Column Electrical Components - System Operation and Component Description .
DTC Fault Trigger Conditions
DTC Description Fault Trigger Condition SCCM U0422:08 Invalid Data Received From Body Control Module: Bus Signal/Message Failures This DTC sets when the SCCM recieves an invaild message from the BCM. SCCM U053B:08 Invalid Data Received From Image Processing Module A: Bus Signal/Message Failures This DTC sets when the SCCM recieves an invaild message from the IPMA. Possible Sources
- SCCM
- P1 CHECK FOR DTC U0422:08, U053B:08
- Ignition ON.
- Using a diagnostic scan tool, carry out the SCCM self test.
Is DTC U0422:08 or U053B:08 present?
Yes For U0422:08 REFER to: Body Control Module (BCM) . For U053B:08, REFER to: Lane Keeping System . No The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector. ADDRESS the root cause of any connector or pin issues.