Driver Multi-Contour Seat Module [SCMG]: Removal

WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: This step is necessary only when installing a new component.

NOTE: The PMI (programmable module installation) process must begin with the current SCMG (driver multi-contour seat module) installed. If the current SCMG (driver multi-contour seat module) does not respond to the diagnostic scan tool, the tool may prompt for As-Built Data as part of the repair.

Using a diagnostic scan tool, begin the PMI process for the SCMG following the on-screen instructions.

Front seat backrest
NOTE: The front seat backrest driver seat SCMG (driver multi-contour seat module)/passenger seat SCMH (passenger multi-contour seat module) is part of the front seat power lumbar assembly and is serviced as an assembly.

Remove the front seat power lumbar assembly. Refer to: Front Seat Power Lumbar Assembly - Vehicles With: Multi-Contour Seats .

Front seat cushion
NOTE: The front seat cushion driver seat SCMG (driver multi-contour seat module) is part of the front seat cushion adjuster and is serviced as an assembly.

NOTE: The front seat cushion passenger seat SCMH (passenger multi-contour seat module) is part of the front seat cushion adjuster and is serviced as an assembly with the OCS (occupant classification system) and the cushion foam.

Remove the front seat cushion adjuster. Refer to: Front Seat Cushion Adjuster - Vehicles With: Multi-Contour Seats .