Pinpoint Test J: U2300: 64
WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
- DTC Fault Trigger Conditions
DTC Description Fault Trigger Condition TCCM U2300: 64 Central Configuration: Signal Plausibility Failure Sets when the TCCM detects signal plausibility failure. Possible Sources
- TCCM
- J1 VERIFY THE CUSTOMER CONCERN
- Ignition ON.
- Verify there is an observable symptom present.
Is the TCCM detects signal plausibility failure?
Yes This DTC sets when configuration data parameters (gearbox type, axle ratio, tire circumference) are valid, but out of the calibrated parameters (e.g. 7: 1 axle ratio). Perform a PMI procedure on the TCCM using As-Built data. If the PMI procedure is unsuccessful or the DTC persists, INSTALL a new TCCM. REFER to: Transfer Case Control Module (TCCM) . . No The repair is completed.