Pinpoint Test I: U2300: 56
WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
- DTC Fault Trigger Conditions
DTC Description Fault Trigger Condition TCCM U2300: 56 Central Configuration: Invalid/Incompatible Configuration Sets when the TCCM detects certain calibration parameters are Invalid / Incompatible configuration. Possible Sources
- TCCM
- I1 VERIFY THE CUSTOMER CONCERN
- Ignition ON.
- Verify there is an observable symptom present.
Is the TCCM detects certain calibration parameters are Invalid / Incompatible configuration?
Yes This DTC sets when configuration data parameters (gearbox type, axle ratio, tire circumference) are corrupt or incompatible configuration (e.g. 2WD with 1 speed transfer case). Perform a PMI procedure on the TCCM using As-Built data. If the PMI procedure is unsuccessful or the DTC persists, INSTALL a new TCCM. REFER to: Transfer Case Control Module (TCCM) . . No The repair is completed.