Diagnostic Trouble Code (DTC) Chart
WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
Diagnostics in this article assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods .
Diagnostic Trouble Code Chart
| Module | DTC | Description | Action |
|---|---|---|---|
| TCCM | P0562:00 | System Voltage Low: No Sub Type Information | GO to Pinpoint Test A |
| TCCM | P0563:00 | System Voltage High: No Sub Type Information | GO to Pinpoint Test A |
| TCCM | P185D:00 | Differential Lock-Up Control Circuit Performance: No Sub Type Information | GO to Pinpoint Test B |
| TCCM | P187A:00 | Transfer Case Control Module System Voltage Low - Rear Locking Differential Disabled: No Sub Type Information | GO to Pinpoint Test C |
| TCCM | P187C:00 | Differential Lock-Up Control Circuit/Open: No Sub Type Information | GO to Pinpoint Test C |
| TCCM | P187D:00 | Differential Lock-Up Control Circuit Low: No Sub Type Information | GO to Pinpoint Test C |
| TCCM | P187E:00 | Differential Lock-Up Control Circuit High: No Sub Type Information | GO to Pinpoint Test D |
| TCCM | U0100:00 | Lost Communication With ECM/PCM "A": No Sub Type Information | GO to Pinpoint Test E |
| TCCM | U0101:00 | Lost Communication with TCM: No Sub Type Information | GO to Pinpoint Test E |
| TCCM | U0121:00 | Lost Communication With Anti-Lock Brake System Control Module: No Sub Type Information | GO to Pinpoint Test E |
| TCCM | U0138:00 | Lost Communication with All Terrain Control Module: No Sub Type Information | GO to Pinpoint Test E |
| TCCM | U0140:00 | Lost Communication With Body Control Module: No Sub Type Information | GO to Pinpoint Test E |
| TCCM | U0439:00 | Invalid Data Received From All Terrain Control Module: No Sub Type Information | GO to Pinpoint Test M |
| TCCM | U2300:54 | Central Configuration: Missing Calibration | GO to Pinpoint Test G |
| TCCM | U2300:55 | Central Configuration: Not Configured | GO to Pinpoint Test H |
| TCCM | U2300:56 | Central Configuration: Invalid/Incompatible Configuration | GO to Pinpoint Test I |
| TCCM | U2300:64 | Central Configuration: Signal Plausibility Failure | GO to Pinpoint Test J |
| TCCM | U3000:04 | Control Module: System Internal Failures | GO to Pinpoint Test L |
| TCCM | U3000:46 | Control Module: Calibration/Parameter Memory Failure | GO to Pinpoint Test K |
| TCCM | U3000:47 | Control Module: Watchdog/Safety μC Failure | GO to Pinpoint Test N |
| TCCM | U3000:49 | Control Module: Internal Electronic Failure | GO to Pinpoint Test L |
| TCU | U0418:00 | Invalid Data Received from Brake System Control Module "A": No Sub Type Information | GO to Pinpoint Test F |