Pinpoint Test C: Driveline Clunk- Fastener Torque To Transmission And Rear Axle
WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
- Normal Operation and Fault Conditions
The driveline system enables the power generated by the engine and transferred through the transmission and, if applicable, transfer case, to place the vehicle in motion. Rotational torque received from the transmission or transfer case is delivered to the front and rear drive axles by way of the driveshafts. The U-joints or CV joints at the ends of the shafts allow the shafts to rotate smoothly in an allowable angle plane. The rotational torque is introduced into the axle differential which drives the axles/halfshaft.
Possible Sources
- Loose or crossthreaded fasteners
- C1 CHECK FOR LOOSE OR CROSSTHREADED FASTENERS
- Check for loose or crossthreaded fasteners.
Are any fasteners loose?
Yes Install new fasteners or install a new driveshaft U-joint or driveshaft as necessary. REFER to: Driveshaft Universal Joint . REFER to: Rear Driveshaft . No Inspect the vehicle for any other symptoms related to the driveshaft.