Removal And Installation: Muffler: Removal

WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Removal steps in this procedure may contain installation details.

With the vehicle in NEUTRAL, position it on a hoist. Refer to: Jacking and Lifting - Overview .
Remove the tailpipe. Refer to: Tailpipe .
NOTE: The muffler inlet pipe must be supported to prevent its free weight from damaging the exhaust heat exchanger during removal.
1. Secure the muffler inlet pipe using mechanics wire.
2. Remove the isolator bolt.
  Torque
  
  : 22 lb.ft (30 Nm)
3. Remove the isolator bolts.
  Torque
  
  : 22 lb.ft (30 Nm)
4. NOTE: During Installation, make sure the button is fully seated in the R-notch on the muffler inlet pipe.
  
  Loosen the clamp. Rotate the muffler assembly and remove it from the vehicle.

Courtesy of FORD MOTOR COMPANY