Muffler and Tailpipe: Removal

WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Muffler and tailpipe assemblies will vary in configuration with different wheelbases and powertrains. Typical application shown in illustration.

NOTE: Removal steps in this procedure may contain installation details.

With the vehicle in NEUTRAL, position it on a hoist. Refer to: Jacking and Lifting - Overview .
Loosen the clamp.
Torque

: 41 lb.ft (55 Nm)

Courtesy of FORD MOTOR COMPANY
Loosen the muffler inlet pipe bolts.
Torque

: 30 lb.ft (40 Nm)

Courtesy of FORD MOTOR COMPANY
Rotate the muffler inlet pipe to allow the muffler and tailpipe assembly to be released.

Courtesy of FORD MOTOR COMPANY
Slide the muffler and tailpipe rearward out of the isolators and remove the muffler and tailpipe.

Courtesy of FORD MOTOR COMPANY

Isolator hanger bracket

NOTE: The following steps are only required if you are replacing the isolators.
NOTE: The isolator must be installed using the same bolt installation sequence as the removal process.
1. Remove the bottom frame rail bolt.
  Torque
  
  : 22 lb.ft (30 Nm)
2. Remove the side frame rail bolt and the isolator.
  Torque
  
  : 22 lb.ft (30 Nm)
Courtesy of FORD MOTOR COMPANY
Remove the bolt and the isolator.
Torque

: 22 lb.ft (30 Nm)

Courtesy of FORD MOTOR COMPANY