Pinpoint Test H: Lost Communication With RCM Concern
WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
Normal Operation and Fault Conditions
With the ignition ON, the GWM sends messages to the SECM over the HS-CAN2 and through the SASM. If the SECM does not receive these messages within a certain time frame, the SECM sets a DTC. For information on the messages sent to the SECM by the GWM, refer to the Network Message Chart .
DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Condition |
|---|---|---|
| SECM U0151:00 | Lost Communication With Restraints Control Module: No Sub Type Information | Sets when the SECM detects any of the RCM messages are missing. This can be due to a RCM failure, a circuit failure on the HS-CAN2 or an excessive load on the network. |
Possible Sources
- Network communication concern
- Charging system concern
- SASM
- RCM
- SECM