LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2022 >> Transit Connect Titanium, Gas/Ethanol >> Repair and Diagnosis >> External Pages >> Different car >> Section 527 (Engine Controls - Pinpoint Test JD: Crankshaft Position (CKP) Sensor Through Pinpoint Test Z: Intermittent - (Except Diesel & Hybrid)) >> PINPOINT TEST QC: On Board Diagnostic (OBD) Systems Readiness >> Test Procedure

Test Procedure

WARNING: This page does not describe the selected car, but rather 34 other vehicles, including the 2019 Lincoln Navigator, 2019 Lincoln Nautilus, 2019 Lincoln MKZ, 2019 Lincoln MKT, and 2019 Lincoln MKC. However, it is still accessible from the selected car via links, so may be relevant.
  1. QC1 CHECK FOR PTO 

    Is the vehicle equipped with PTO? 

    Yes No
    GO to  QC2. INFORM the customer the law in your area may require additional driving to complete an inspection/maintenance test.
  2. QC2 CHECK THE PTO PID 
    • Ignition ON, engine running.
    • Access the PCM and monitor the PTO_STATUS (MODE) PID.
    • Cycle the PTO switch/actuator ON and OFF. (Follow the PTO aftermarket instructions).

    Does the PTO PID cycle ON and OFF? 

    Yes No
    INFORM the customer the law in your area may require additional driving to complete an inspection/maintenance test. GO to PINPOINT TEST FB .