LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2022 >> Transit Connect Titanium, Gas/Ethanol >> Repair and Diagnosis >> External Pages >> Different car >> Section 513 (Electronic Power Assist Steering (EPAS) Guided Routine) >> Pinpoint Tests >> Pinpoint Tests Y: PSCM DTC P061A Internal Control Module Torque Performance >> Pinpoint Test Purpose

Pinpoint Test Purpose

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2021 Lincoln Corsair, 2021 Lincoln Aviator, 2021 Ford Transit-350 HD, 2021 Ford Transit-350, and 2021 Ford Transit-250. However, it is still accessible from the selected car via links, so may be relevant.

To verify PSCM DTC P061A is present and provide diagnostics if DTC P061A is currently active in the PSCM.

  1. Y1: CHECK FOR OVERHEATING DTC 
    • Ignition ON, engine OFF.
    • Clear the PSCM DTCs.
    • Ignition OFF.
    • Wait at least 90 seconds for the modules to completely shut off.
    • Start the vehicle.
      • Make sure the engine ready indicator is illuminated for hybrid vehicles.

    Carry out the PSCM self-test.

    • Is DTC P061A:xx present and active in the PSCM? 
    Yes No
    INSTALL a new EPAS gear.
    REFER to the Power Steering article.
    ORDER a replacement EPAS gear and INCLUDE the RVC on the form.
    If this is a Ford paid repair, INCLUDE the RVC on the warranty claim form.
    INCLUDE the tie rods and boots with the steering gear.
    SHIP the steering gear in the original box and packing foams to prevent steering gear damage.
    REFER to GSBs for return shipping packaging instructions.
    If the PSCM does not list DTC P061A, DISCONTINUE this test and REFER to the DTC Chart for direction.