LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2022 >> Transit Connect Titanium, Gas/Ethanol >> Repair and Diagnosis >> External Pages >> Different car >> Section 513 (Electronic Power Assist Steering (EPAS) Guided Routine) >> Pinpoint Tests >> Pinpoint Tests Cr: PSCM DTC U202B In-Use Application Signing Key >> Pinpoint Test Purpose

Pinpoint Test Purpose

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2021 Lincoln Corsair, 2021 Lincoln Aviator, 2021 Ford Transit-350 HD, 2021 Ford Transit-350, and 2021 Ford Transit-250. However, it is still accessible from the selected car via links, so may be relevant.

To verify PSCM DTC U202B is present and provide diagnostics if DTC U202B is currently active in the PSCM.

  1. CR1: VERIFY THE PSCM DTC 
    • Ignition ON, engine OFF.
    • Clear the PSCM DTCs.
    • Ignition OFF.
    • Wait at least 90 seconds for the modules to completely shut off.
    • Start the vehicle.
      • Make sure the engine ready indicator is illuminated.

    Carry out the PSCM self-test.

    • Is DTC U202B:XX present and active in the PSCM? 
    Yes No
    INSTALL a new EPAS gear.
    REFER to the Power Steering article.
    ORDER a replacement EPAS gear and INCLUDE the RVC on the form.
    If this is a Ford paid repair, INCLUDE the RVC on the warranty claim form.
    INCLUDE the tie rods and boots with the steering gear. SHIP the steering gear in the original box and packing foams to prevent steering gear damage.
    REFER to GSBs for return shipping packaging instructions.
    If the PSCM does not list DTC U202B:XX,
    DISCONTINUE this test and REFER to the DTC Chart for direction.