Pinpoint Test Purpose
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2021 Lincoln Corsair, 2021 Lincoln Aviator, 2021 Ford Transit-350 HD, 2021 Ford Transit-350, and 2021 Ford Transit-250. However, it is still accessible from the selected car via links, so may be relevant.
To verify the presence of DTC U0422 and identify the correct Service Information for diagnosing the DTC concern.
- BU1: CHECK PSCM DTC
- Start the vehicle.
- Make sure the engine ready indicator is illuminated.
Carry out the PSCM self-test.
- Is DTC U0422:xx currently present and active in the PSCM?
Yes No Go to BU2. If the PSCM does NOT list DTC U0422 Invalid Data Received from the BCM, DISCONTINUE this test and REFER to the DTC Chart for diagnostic direction. - Start the vehicle.
- BU2: CHECK THE VEHICLE BATTERY AND CHARGING SYSTEM VOLTAGE
- Ignition ON, engine OFF.
- Refer to the Charging System General Information article and carry out Pinpoint Test A: Battery Condition Test (battery state of charge).
- Did the battery pass the condition test (battery state of charge)?
Yes No Go to BU3. INSTALL a new 12-volt battery. REFER to the Battery, Mounting and Cables article. Go to BU3. - BU3: RECHECK THE PSCM DTC
- Ignition ON, engine OFF.
- Clear the PSCM DTCs.
- Ignition OFF.
- Start the vehicle.
- Make sure the engine ready indicator is illuminated.
Carry out the PSCM self-test.
- Is DTC U0422:xx currently present and active in the PSCM?
Yes No DIAGNOSE the BCM concern. REFER to the Multifunction Electronic Modules article. The concern is not present at this time and may have been set due to a low battery state of charge. The test is complete, no further action is required.