Pinpoint Test Purpose
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2021 Lincoln Corsair, 2021 Lincoln Aviator, 2021 Ford Transit-350 HD, 2021 Ford Transit-350, and 2021 Ford Transit-250. However, it is still accessible from the selected car via links, so may be relevant.
To verify DTC U2100 is present in the PSCM and to provide diagnostics if DTC U2100 is currently present and active in the PSCM.
- BQ1: CHECK VEHICLE HISTORY
- Check the vehicle history for recent service actions related to the:
- PSCM
- Steering gear
- Steering column
- Electronic steering actuator
- Have there been any recent service actions related to the components listed above?
Yes No REPEAT the PMI procedure as directed by the diagnostic scan tool or CONFIGURE the PSCM using vehicle as-built data. Go to BQ2. - Check the vehicle history for recent service actions related to the:
- BQ2: VERIFY PSCM CONFIGURATION
- Ignition ON, engine OFF.
- Using a diagnostic scan tool, configure the PSCM. Refer to the Module Configuration article.
- Ignition OFF.
- Wait at least 90 seconds for the modules to completely shut off.
- Start the vehicle.
- Make sure the engine ready indicator is illuminated.
Carry out the PSCM self-test.
- Is DTC U2100:XX present and active in the PSCM?
Yes No Using a diagnostic scan tool, CONFIGURE the PSCM.
REFER to the Module Configuration article.
DO NOT install a new EPAS assembly. DTC U2100 is present in new EPAS assemblies until the PSCM is correctly programmed and configured. DOWNLOAD the latest PMI/IDS scan tool program to make sure the latest PMI software is being used.The condition causing the DTC is not present at this time.