Lack Of Assist, Intermittent Or Inconsistent Assist - EPAS System

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2021 Lincoln Corsair, 2021 Lincoln Aviator, 2021 Ford Transit-350 HD, 2021 Ford Transit-350, and 2021 Ford Transit-250. However, it is still accessible from the selected car via links, so may be relevant.

Lack of assist or inconsistent assist is experienced when the steering wheel effort is higher than normal. Hard steering can remain constant through the full turn or occur near the end of a turn. Intermittent assist is experienced when the steering wheel effort is normal, then high, then normal, intermittently, causing a notchy steering feel.
NOTE: There are multiple conditions (overheating protection, high voltage, low voltage, etc.) which result in limited or reduced assist from the EPAS system. Address all existing PSCM DTCs prior to diagnosing any assist symptoms.

NOTE: For some low voltage conditions the message center may display: STEERING ASSIST FAULT SERVICE REQUIRED. This does not indicate a concern with the PSCM if only DTC U3003:xx is present. The status of the 12-volt battery should be evaluated.

NOTE: If the steering wheel is held at the end of travel for more than 2 seconds, the PSCM noticeably reduces assist to the EPAS gear. This is a normal condition programmed into the PSCM to protect the system from permanent damage.
If equipped, active park assist, Lane Centering Assist (LCA) and Lane Keeping Assist (LKA) can only be activated if the steering system is providing full steering assist. If the steering assist feature is currently in use and the steering system experiences a partial or non-assist event, the steering assist feature is deactivated.

Possible Source	Action
Fuse(s) Wiring, terminals or connectors 12-volt battery Suspension components Steering gear internal failure Loose, damaged or worn inner or outer tie rods	GO to PINPOINT TEST BK.