LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2022 >> Transit Connect Titanium, Gas/Ethanol >> Repair and Diagnosis >> External Pages >> Different car >> Section 501 (Engine Controls - Powertrain DTC Charts & Descriptions (Except Diesel & Hybrid)) >> Diagnostic Trouble Code (DTC) Charts And Descriptions >> P130D - Engine Knock/Combustion Performance - Forced Limited Power

P130D - Engine Knock/Combustion Performance - Forced Limited Power

WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 2021 Lincoln Navigator, 2021 Lincoln Nautilus, 2021 Lincoln Corsair, 2021 Lincoln Aviator, and 2021 Ford Transit-350 HD. However, it is still accessible from the selected car via links, so may be relevant.
DTC DESCRIPTION P130D - ENGINE KNOCK/COMBUSTION PERFORMANCE - FORCED LIMITED POWER

Description:  This DTC sets when the knock control system (KCS) detects excessive pre-ignition. The knock sensor (KS) voltage exceeds a maximum value greater than a calibrated number of times within a set time period when pre-ignition is present.
Possible Causes: 
  • Fuel quality
  • Base engine concerns
  • Cooling system concerns
  • Damaged spark plug
  • Incorrect or corroded connections on ignition system harness connectors
  • Lean fuel injector
  • Long term fuel trim at lean limits
  • Positive crankcase ventilation (PCV) system is leaking or stuck open
  • Oil overfilled
  • Oil and filter maintenance beyond recommended intervals
  • Excessive oil consumption
  • Charge air cooler (CAC) restriction
Diagnostic Aids:  Engine performance may be limited to protect the engine if this DTC is set.
This DTC may be accompanied by other DTCs. Diagnose all other DTCs first. If no other DTCs are present, verify no base engine concerns are present before continuing with diagnosis. Refer to the appropriate Engine System article.
The following driving conditions may cause this DTC to set: heavy acceleration from a stop, towing, carrying a heavy load or driving up a grade during a boost condition.
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
All GO to Pinpoint Test DG.