Pinpoint Tests Purpose
WARNING: This page is about a different car, the 2020 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
To verify PSCM DTC U3002 is present and provide diagnostics if DTC U3002 is currently present and active in the PSCM.
- BR1: CHECK VEHICLE HISTORY
- Check the vehicle history for recent service actions related to the PSCM or steering column.
- Have there been any recent service actions related to the PSCM or steering column?
Yes No REPEAT the PMI procedure as directed by the diagnostic scan tool or CONFIGURE the PSCM using vehicle as-built data. Go to BR2.
- BR2: CONFIGURE THE IPC
- Ignition ON, engine OFF.
- Using a diagnostic scan tool, configure the IPC. Refer to the Module Configuration article
- Ignition OFF.
- Ignition ON, engine OFF.
- Clear the PSCM DTCs.
- Ignition OFF.
- Wait at least 90 seconds for the modules to completely shut off.
- Ignition ON, engine OFF.
Carry out the PSCM self-test.
- Does DTC U3002:xx return?
Yes No INSTALL a new EPAS steering column.
REFER to the Steering Column article.
ORDER a replacement EPAS column and INCLUDE the RVC on the order form.
If this is a Ford paid repair, INCLUDE the RVC on the warranty claim form.The condition causing the DTC is not present at this time.