Auto Start Stop

WARNING: This page is about a different car, the 2020 Ford F-550 Super Duty, 2020 Ford F-450 Super Duty, 2020 Ford F-350 Super Duty, 2020 Ford F-250 Super Duty, and 2020 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

The auto start stop system helps reduce fuel consumption and decrease emissions by automatically shutting down the engine when the vehicle stops and the engine is idling, usually within 1500 ms (1.5 seconds). To initiate the auto start stop operation, the vehicle gear selector must be in DRIVE when the vehicle comes to a stop and the brake pedal must be fully applied. The engine automatically restarts when the brake pedal is released, usually within 200 ms (0.5 seconds), or when a vehicle system requires a restart, for example to recharge the battery or to maintain interior comfort settings.

The auto start stop system is defaulted to an ON state when the engine is started. To switch the auto start stop system OFF, press the auto start stop switch located on the center console. To turn the auto start stop system ON, press the auto start stop switch again. The auto start stop system can only be deactivated during the current ignition cycle.

The instrument panel cluster (IPC) auto start stop indicator illuminates when an auto start stop system inhibit or disable condition is present.

During normal operation the auto start stop system may not stop the engine under the following conditions:

The A/C, heat or defrost settings are ON
The rear defroster is ON
The battery has a low state of charge or is below 5°C (41°F) or above 60°C (140°F)
The maximum engine off time is exceeded
The engine operating temperature is less than 60°C (140°F)
The gear selector is in the PARK, REVERSE, NEUTRAL or SECOND GEAR position
The steering wheel is turned rapidly or is at a sharp angle
Initial vehicle speed of greater than 4 km/h (2.5 MPH) and less than 2 seconds has elapsed
The vehicle is on a steep road grade
Elevation is above 10, 000 feet (3, 048 meters) approximately
The clutch pedal position (CPP) sensor indicates the clutch pedal is fully released

Any of the following conditions may result in an automatic restart of the engine:

The blower fan speed is increased or the climate control temperature is changed
An electrical accessory is turned ON or plugged in
Incorrect brake vacuum
The auto start stop switch is pressed to disable the system while the engine is stopped